Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Prestressed frequency analysis

Posted 2015年9月11日 GMT-4 12:19 Studies & Solvers, Structural Mechanics 0 Replies

Ajay Bhat
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hey,
I am trying to simulate a 5mm square, 200nm thick membrane's mechanical motion. The membrane is fixed on a 1mm thick silicon substrate.

I have included a initial stress, done the stationary-->eigenfrequency analysis and found the modes.

Now I want to study the amplitude of the mode as a function of different actuation points in the substrate. For this, I am trying to run the Stationary-->Freq Dom, Perturbation analysis with a harmonic perturbation boundary load (at and close to the mode resonance freq) at different regions of the substrate.
The frequency domain solution is not converging.

Any lead would be appreciated.

Regards,
Ajay
0 Replies Last Post 2015年9月11日 GMT-4 12:19
COMSOL Moderator

Hello Ajay Bhat

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content