Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
[Moving Mesh] Changing unit (dm>mm) leads to inverted mesh
Posted 2010年9月16日 GMT-4 04:00 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
I have a model which works well when I use a macroscale (like meters), but, when I change the scale (millimeters), the calculation leads to inverted meshes.
As I changed everything in the same proportion, I have expected that only the physics would change (here Navier-Stokes > Stokes flow), but apparently some geometry/meshes are also changed.
Could you give me some hints on what to look for, because I really don't understand this behaviour.
Thank you in advance
I have a model which works well when I use a macroscale (like meters), but, when I change the scale (millimeters), the calculation leads to inverted meshes.
As I changed everything in the same proportion, I have expected that only the physics would change (here Navier-Stokes > Stokes flow), but apparently some geometry/meshes are also changed.
Could you give me some hints on what to look for, because I really don't understand this behaviour.
Thank you in advance
1 Reply Last Post 2010年9月16日 GMT-4 08:05
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
check carefully the new sizes of your model, depending if you hit the scale values check box, COMSOL's logic was not the same as mine, so I had too some surprises in the beginning. ;)
--
Good luck
Ivar
check carefully the new sizes of your model, depending if you hit the scale values check box, COMSOL's logic was not the same as mine, so I had too some surprises in the beginning. ;)
--
Good luck
Ivar