Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Vibration Based piezoelectric Energy Harvester

Please login with a confirmed email address before reporting spam

Hi Everyone
I want to know how to give vibrational input in cantilever beam model also I want to know how to decide d33 or d31 mode of piezoelectric material. I try to run following model "Simulation of a New PZT Energy Harvester with a Lower Resonance Frequency Using COMSOL Multiphysics®" by H. Elbahr,*, T. A. Ali, A. Badawi, and S. Sedky which is attached below.


0 Replies Last Post 2015年12月3日 GMT-5 06:05
COMSOL Moderator

Hello Pankaj Kumar Sharma

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.