M. Puskarczyk, R. Jez 
ABB Corporate Research Center, Krakow, Poland
Multilayer planar transformers are widely implemented in power electronic applications. The design process of these elements is complicated due to the ...
L. R. de Souza Jr., L. Lorenz
Universidade Federal do Paraná, Curitiba, Paraná, Brazil
In the core of Chemical Engineering is the reactor design that includes most of all scientific disciplines. The reactors, in general, are treated ...
E. Ruiz-Reina , F. Carrique , A.V. Delgado , M.M. Fernández ,
 Department of Applied Physics II, University of Málaga, Málaga, Spain
 Department of Applied Physics I, University of Málaga, Málaga, Spain
 Department of Applied Physics, University of Granada, Granada, Spain
Capacitive energy extraction based on double layer expansion (CDLE) is a new method devised for extracting energy from the exchange of fresh and salty ...
M. K. Gobbert, X. Huang, S. Khuvis, S. Askarian, B. E. Peercy
University of Maryland - Baltimore County, Baltimore, MD, USA
This paper presents information on techniques needed in COMSOL Multiphysics® to enable computational studies of coupled systems of PDEs for time ...
University of Manchester, Manchester, UK
This report mainly discusses the implementation and results of a project proposal, “Modelling using Finite Element Methods”. The report is devoted to ...
A Practical Method to Model Complex Three-Dimensional Geometries with Non-Uniform Material Properties Using Image-based Design and COMSOL Multiphysics®
J. Cepeda, S. Birla, J. Subbiah, H. Thippareddi
Department of Food Science & Technology, University of Nebraska, Lincoln, NE, USA
Department of Biological Systems Engineering, University of Nebraska, Lincoln, NE, USA
Geometries with heterogeneous material properties are typically defined as a set of multiple parts, each part representing a different material. ...
Toyota Research Institute of North America, Ann Arbor, Michigan, USA
This paper is focused on topology optimization of heat transfer and fluid flow systems for multiphysics objectives. Specifically, COMSOL Multiphysics ...
L. Spicci, and M. Cati
The present paper describes the development of a full FEM model for linear array high performance 5MHz ultrasound imaging transducer. As a preliminary ...
E. Licon, S. Casas, A. Alcaraz, J.L. Cortina, C. Valderrama
Universitat Politécnica de Catalunya, Barcelona, Spain
Ammonia separation from water by membrane contactor was simulated on transient state and compared with experimental data. Aqueous low concentrated ...
D. Iber, D. Menshykau, P. Germann, L. Lermuzeaux[2,3]
D-BSSE, ETH Zurich, Switzerland, SIB, Basel, Switzerland
D-BSSE, ETH Zurich, Basel, Switzerland
Department of Bioengineering, University of Nice-Sophia Antipolis, Nice, France
Morphogenesis is a tightly regulated process that has been studied for decades. Previously we developed data-based mechanistic models for a range of ...