了解多物理场仿真在基础研究和产品设计中的应用

各个行业的工程师和科研人员都在使用多物理场仿真来研发创新的产品设计和流程。他们在 COMSOL 用户年会上展示了丰富的技术论文和演示文稿,您可以从他们的研究成果中寻找灵感。

使用左侧【快速搜索】工具查找您感兴趣的研究,或按照应用领域进行筛选。


查看 COMSOL 用户年会 2020 论文

Structural Mechanics and Thermal Stressesx

Assessment of Squeeze-off Location for Small Diameter Polyethylene (PE) Pipe and Tubing

O. Lever [1], E. Lever [1],
[1] Gas Technology Institute, Des Plaines, IL, USA

This poster showcases a fully parametric, nonlinear, time-dependent polyethylene (PE) pipe squeeze-off model ... 扩展阅读

High-Resolution FSI Modeling of a High-Aspect Ratio Involute Flow Channel in the HFIR at ORNL

A. I. Elzawawy [1], J. D. Freels [2], F. G. Curtis [2, 3],
[1] Vaughn College of Aeronautics and Technology, East Elmhurst, NY, USA
[2] Oak Ridge National Laboratory, Oak Ridge, TN, USA
[3] University of Tennessee, Knoxville, TN, USA

The high flow rate within the HFIR cooling water flow channel causes the fuel plates to deflect which in ... 扩展阅读

Structural Analysis of the Advanced Divertor eXperiment's Proposed Vacuum Vessel

J. Doody [1], R. Vieira [1], B. LaBombard [1], R. Leccacorvi [1], J. Irby [1], R. Granetz [1]
[1] Plasma Science and Fusion Center - Massachusetts Institute of Technology, Cambridge, MA, USA

The goal of a tokamak is to use high magnetic fields to contain plasma and produce nuclear fusion that can be ... 扩展阅读

Simulation of a Buckled Cantilever Plate with Thermal Bimorph Actuators

A. Arevalo [1], D. Conchouso [1], D. Castro [1], M. Diaz [2], I. G. Foulds [3],
[1] CEMSE Division, King Abdullah University of Science and Technology, Thuwal, Saudi Arabia
[2] Physical Sciences and Engineering Division, King Abdullah University of Science and Technology, Thuwal, Saudi Arabia
[3] University of British Columbia, Vancouver, BC, Canada

INTRODUCTION: Micro Electro Mechanical Systems (MEMS) are fabricated with an in-plane fabrication technology. ... 扩展阅读

Simulation of the Cooling and Phase Change of a Melt-Cast Explosive

W. Sanhye [1], C. Dubois [1], P. Pelletier [2], I. Laroche [2],
[1] Department of Chemical Engineering, École Polytechnique de Montréal, Montréal, QC, Canada
[2] General Dynamics Ordnance and Tactical Systems-Canada Inc., Repentigny, QC, Canada

Introduction Numerical modeling of melt-casting is becoming a popular tool for the energetic materials and ... 扩展阅读

Simulation of a Dual Axis MEMS Seismometer For Building Monitoring System

M. A. Shah [1], F. Iqbal [1], B. L. Lee [1],
[1] Korea University of Technology and Education, Cheonan, Chungcheong, South Korea

A dual axis MEMS seismometer targeted for building monitoring system has been simulated for a full scale of ... 扩展阅读

Snap Buckling of a Constrained Photomechanical Switch Driven by Elastic Instability

M. L. Smith [1], A. A. Sicard [1], A. A. Skandani [2], M. R. Shankar [2],
[1] Hope College, Holland, MI, USA
[2] University of Pittsburgh, Pittsburgh, PA, USA

Photomechanical materials experience strains in response to light of certain wavelengths. These remotely ... 扩展阅读

Advanced Multiphysics Thermal Hydraulic Models for the High Flux Isotope Reactor

P. K. Jain [1], J. D. Freels [1],
[1] Oak Ridge National Laboratory, Oak Ridge, TN, USA

Engineering design studies of the feasibility of conversion of the High Flux Isotope Reactor (HFIR) from high ... 扩展阅读

A Comparison of Mass Reduction Methods for Silicon-on-Oxide (SOI)-based Micromirrors

H. J. Hall [1], L. A. Starman [1],
[1] Sensors Directorate, Air Force Research Laboratory, Wright-Patterson AFB, OH, USA

Beam steering and adaptive optics micromirror applications commonly demand optically flat surfaces with ... 扩展阅读

Statistical Modeling and Contact Analysis of RF MEMS Surface

J. Liu [1], V. B. Chalivendra [1], C. Goldsmith [2], W. Huang [1],
[1] Department of Mechanical Engineering, University of Massachusetts - Dartmouth, Dartmouth, MA, USA
[2] MEMtronics Corporation, Richardson, TX, USA

Radio frequency (RF) micro-electro mechanical system(MEMS) switch works in on/off modes controlled by ... 扩展阅读