Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Can Pipe Flow Module not cool solids from the outside?

Posted 2016年1月13日 GMT-5 10:14 Heat Transfer & Phase Change Version 5.1 0 Replies

Andrew Bopp
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I would like to model a heat generating cylinder (nuclear fuel rod) that is cooled by fluid flowing around it (coolant). I would like to use Heat Transfer in Solids for the "fuel rod", and I would like to model "coolant" flowing around the outside as internal flow in a heated pipe . In other words, I want a model that assigns the heat ouput of the fuel rod to the heat input of the "coolant" pipe. I am unsure how to couple the models so that the outside wall of the "fuel rod" has the same temperature/heat flux as the outside wall of the "coolant" pipe.

How can I do this? CFD is not an option. While I have a license for the module, it will be too computationally expensive for what I am planning.

0 Replies Last Post 2016年1月13日 GMT-5 10:14
COMSOL Moderator

Hello Andrew Bopp

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content