Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Internal No-Flux boundary condition
Posted 2016年3月1日 GMT-5 00:16 Fluid & Heat, Computational Fluid Dynamics (CFD), Battery Design, Chemical Reaction Engineering Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
I am modeling a fuel cell with the reacting flow in porous media (rfcs) interface and I would like to make it so H2O is able to transfer through out the entire model, but H2 must remain in the anode compartment and O2,N2 must remain in the cathode compartment. There is a thin membrane separating the anode and cathode compartments where the only species present should be H2O.
I am trying to somehow set a no flux boundary condition for species H2 at the anode compartment/ membrane interface. I also need to set a no flux boundary condition for species O2,N2 at the cathode compartment/ membrane interface.
I think the answer might rest on using an assembly node, but I could really use some help.
I am trying to somehow set a no flux boundary condition for species H2 at the anode compartment/ membrane interface. I also need to set a no flux boundary condition for species O2,N2 at the cathode compartment/ membrane interface.
I think the answer might rest on using an assembly node, but I could really use some help.
Attachments:
1 Reply Last Post 2016年3月4日 GMT-5 15:52
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi Mike,
You might want to try contacting COMSOL Support. www.comsol.com/support
They are the ones to go to for tech questions.
David
You might want to try contacting COMSOL Support. www.comsol.com/support
They are the ones to go to for tech questions.
David