Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Periodic holes in a metal film...showing error..please help

Posted 2016年3月5日 GMT-5 04:49 RF & Microwave Engineering Version 4.4 0 Replies

Kalpana Singh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hi

I have made a hole in a silver metal film. Holes are periodic in the metal film. I have applied Floquet boundary conditions. but I don't know what's the problem, I have tried all kind of meshing as well but still the simulation shows error. I have attached my mph file. I would be very thankful if you please can tell where I m doing wrong.

Thanks
Kalpana

Attachments:

0 Replies Last Post 2016年3月5日 GMT-5 04:49
COMSOL Moderator

Hello Kalpana Singh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content