Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Refining mesh leads to non-physical results

Posted 2016年3月24日 GMT-4 23:16 0 Replies

Lucas Encarnacao
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I'm new to COMSOL and am trying to do a relatively simple analysis of a sphere indenting into a cylindrical plane. I tweaked this model (www.comsol.com/model/cylinder-roller-contact-1431) and made it 2D axisymmetrical so it suited my model. I'm applying a point load to the top of the sphere and am trying to measure the maximum indentation depth. It runs with a coarse mesh (max element size ~10 nm) but any attempt to refine the mesh results in a non-physical result where the solver solves immediately on the first iteration and the sphere buries itself halfway through the plane.

I've attached the model I'm using if that helps.

I would just use the coarser mesh but I need a finer mesh if I am to publish the results because I need the highest accuracy possible. Any help is greatly appreciated! Thanks

Attachments:

0 Replies Last Post 2016年3月24日 GMT-4 23:16
COMSOL Moderator

Hello Lucas Encarnacao

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content