Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Convective heat flux

Please login with a confirmed email address before reporting spam

Hi,
I'm trying to see the heat conduction from the electric power conduit pipe to the soil surrounding the pipe.
The square part which I attached as model.png is the pipe and inside.
I built two point source inside.
Inside the pipe is just air, so I applied the heat transfer in fluid.
Wanted to apply convective heat flux to the pipe walls, but there was only inward heat flux in my version.
So I just applied the inward heat fluxes to the walls.
However, the result came out like result.png. Even though I applied heat transfer in solid and heat transfer fluid for the analysis, it doesn't read the heat conduction or convection inside the pipe box at all.
Anyone knows the solution? using inward heat flux to realize the convective heat flux or finding the convective heat flux.

Is it just the problem of this version?


0 Replies Last Post 2016年5月12日 GMT-4 04:25
COMSOL Moderator

Hello Seunghun Baek

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.