Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem about gradient when using General Extrusion

Posted 2016年7月18日 GMT-4 04:38 Version 5.0, Version 5.1, Version 5.2 0 Replies

Tuan-Anh Le
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have problem when using General Extrusion. After making Magnetic field physics and make General Extrusion in 2D model, I can not get gradient of magnetic field in 3D ( command d( comp1.gx(comp1.mf.Hz),z) get 0), about magnetic field is ok.
Thank you
0 Replies Last Post 2016年7月18日 GMT-4 04:38
COMSOL Moderator

Hello Tuan-Anh Le

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content