Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

A problem in simulating helium gas jet into ambient air

Posted 2010年12月9日 GMT-5 08:54 Fluid & Heat, Computational Fluid Dynamics (CFD), Chemical Reaction Engineering, Studies & Solvers Version 4.0a 2 Replies

Jia Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello, everyone.

I wanna to simulate that how the helium gas jet enters into the ambient air and after several weeks' learning of COMSOL 4.0a, I complete the model as shown in the attached figure.

Basically speaking, this model is coupled with 2 modules, transport of diluted species and single-phase flow--laminar flow. The bulk material is set to be air. These two modules have been coupled by setting the fluid velocity.

However, after calculation, I can get nothing but an error showing that 'can't get a solution' even though I have tried lots of times. I am not sure the boundary setting is right or not, therefore, I put it here and hope that anyone who knows how to solve this problem could help me.


Thanks a lot in advance.

Attachments:

2 Replies Last Post 2010年12月9日 GMT-5 21:51
Mohamed Aref
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2010年12月9日 GMT-5 17:25
Hi

I'm a beginner in comsol
and my graduation project is in ultrasonic flow meter, and i want you if you can to aid me with good tutorials
Thanks,
Hi I'm a beginner in comsol and my graduation project is in ultrasonic flow meter, and i want you if you can to aid me with good tutorials Thanks,
Jia Li
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2010年12月9日 GMT-5 21:51
actually, I have searched lots of time and can't find any useful information. So, I resort to this forum. and of course, I will supply any tutorial which may be useful for you.
actually, I have searched lots of time and can't find any useful information. So, I resort to this forum. and of course, I will supply any tutorial which may be useful for you.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content