Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Induction Heating

Posted 2011年1月18日 GMT-5 14:57 0 Replies

Nicholas Williams
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to heat an iron block using an induction heater. I've been following the tutorial of the Induction Heater, and have been successful in heating the block with the oscillating magnetic field of one ring of current. The tutorial uses a frequency of 20 kHz. The heater that I am trying to model uses a frequency of 60 Hz. The simulation does not converge for any frequencies below 1 kHz. Has anyone been successful in modeling a low frequency induction heater?

The link to the tutorial is below:
www.comsol.com/multiphysics/inductionheating/
0 Replies Last Post 2011年1月18日 GMT-5 14:57
COMSOL Moderator

Hello Nicholas Williams

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content