Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

inverted mesh element -Two phase flow Moving Mesh

Posted 2016年12月9日 GMT-5 04:50 Fluid & Heat, Computational Fluid Dynamics (CFD), Geometry, Mesh Version 5.2 0 Replies

Hamid Aero
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I have a two phase model which I run it through Two phase flow moving mesh interface. I get inverted mesh element warning all the time. The first tip in the case of getting such warning is to change the mesh and to increase the quality of the mesh. I have changed the mesh many times but again and again this warning appears. It seems, I cannot get rid of this warning. I was wondering what would happen If I simply ignore this warning? Does getting this warning mean that I cannot trust the results?

Thank you very much
Hamid
0 Replies Last Post 2016年12月9日 GMT-5 04:50
COMSOL Moderator

Hello Hamid Aero

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content