Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
2D corona Discharge
Posted 2017年2月1日 GMT-5 07:54 Low-Frequency Electromagnetics, Plasma Physics, Geometry, Mesh, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 5.2 1 Reply
Please login with a confirmed email address before reporting spam
Hi everyone
i'm trying to simulate corona discharge between two electrodes in comsol 5.2
the mesh is triangular with boundary layer mesh.
i have built my model based on the example in the software's application libraries
but with different meshes the following errors have occured:
Failed to find consistent initial values.
Last time step is not converged.
can anyone help me with this? i would be very appreciated
i'm trying to simulate corona discharge between two electrodes in comsol 5.2
the mesh is triangular with boundary layer mesh.
i have built my model based on the example in the software's application libraries
but with different meshes the following errors have occured:
Failed to find consistent initial values.
Last time step is not converged.
can anyone help me with this? i would be very appreciated
1 Reply Last Post 2017年2月8日 GMT-5 09:41
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hi,
I have the same problem in plasma DBD discharge.
I have used a very very small mesh ==> the calculation stop in "matrix factorization" after some milliseconds of physical time.
I have used an iterative solver ==> my calculation converged but i have false results
Do you have find a solution ?
Good luck
I have the same problem in plasma DBD discharge.
I have used a very very small mesh ==> the calculation stop in "matrix factorization" after some milliseconds of physical time.
I have used an iterative solver ==> my calculation converged but i have false results
Do you have find a solution ?
Good luck