Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Super simple geometry- self intersection when meshing 5.2.a

Posted 2017年2月3日 GMT-5 09:09 Low-Frequency Electromagnetics, Geometry, Mesh Version 5.2a 2 Replies

Gert Persson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Super simple geometry created using sweep-command
The mesh wont work - self intersection!
I really don't understand how I should create this geometry, is there something I don not understand when it comes to the sweep-command?

Attachments:

2 Replies Last Post 2017年2月4日 GMT-5 09:54
Peter Chang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年2月3日 GMT-5 16:49
Because the way you set up your geometry is self intersecting. Please see the attached file with my geometry sequence.
Because the way you set up your geometry is self intersecting. Please see the attached file with my geometry sequence.

Attachments:

Gert Persson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年2月4日 GMT-5 09:54
Thank you Peter!
Extrude and Revolve works fine, I understand that Sweep is not suitable for this.
Thank you Peter! Extrude and Revolve works fine, I understand that Sweep is not suitable for this.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content