Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Turning Interior Wall Boundary Condition On/off

Please login with a confirmed email address before reporting spam

I am trying to setup a configuration where gas flows between two compressed tanks through a smaller pipe. I have used an interior wall BC across the pipe to simulate a valve that I want to open/close according to a predefined schedule at different times.
Does anyone know how I can switch the Interior Wall BC ON/OFF during the simulation, i.e. turn it from no flux boundary to free flow (continuity) boundary?

Thank you in advance
Andreas

0 Replies Last Post 2017年6月29日 GMT-4 08:58
COMSOL Moderator

Hello Andreas Yiotis

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.