Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Non liear solver convergence problem when mesh is increased...FSI

Please login with a confirmed email address before reporting spam

I run FSI model with low mesh size. This simulation is done without any errors.

And I increase the size of mesh in both of fluid and solid domain. But when I increased I got error in the middle of calculation as following;

Nonlinear solver is not converged.

The quality of mesh is similar between two cases with the range of 0.3 - 0.8 of tetrahedral elements.

This situation is not a first time in FSI. Only with solid modeling this also happened when mesh increased.

I don't understand this because in general it is better with high mesh.

Is there anyone who have a similar situation?

P.S. The server has a enough memory to load all calculation thus I used the direct method to simulation in FSI and only solid moel.

1 Reply Last Post 2011年3月4日 GMT-5 01:17
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年3月4日 GMT-5 01:17
Hi

mostly in FSI you have also the ALE running, that is you deform your mesh, but if the ratio deformation to mesh size becomes critical, the deformation might make the mesh invert or distort too much, so there are cases when a coarse mash works OK ,an intermediate not, and a fine good again. But the best is to identify where you have the problem, and work locally on the mesh to get it to survive the deformations without increasing the mesh density for the full model

--
Good luck
Ivar
Hi mostly in FSI you have also the ALE running, that is you deform your mesh, but if the ratio deformation to mesh size becomes critical, the deformation might make the mesh invert or distort too much, so there are cases when a coarse mash works OK ,an intermediate not, and a fine good again. But the best is to identify where you have the problem, and work locally on the mesh to get it to survive the deformations without increasing the mesh density for the full model -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.