Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Using a block model

Posted 2011年3月16日 GMT-4 19:29 Heat Transfer & Phase Change, Geometry Version 4.1 0 Replies

Benjamin Blakely
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am using a simple block model created in solidworks and i wanted to break up this model into different faces ect. how do i go about doing this with comsol? The intension is to model it transfer from out side the block as if it was a concrete house.
0 Replies Last Post 2011年3月16日 GMT-4 19:29
COMSOL Moderator

Hello Benjamin Blakely

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content