Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Comsol and Matlab - avoid unnecessary recalculations

Please login with a confirmed email address before reporting spam

Hello!


I am working about a flexible model using Comsol 4.1 and Matlab.

Meanwhile the model is quite big and takes already some Minutes of calculation with a very rough mesh and only few couplings.

The problem is, that for obtaining solutions, I have to type mpheval... and for displaying the mesh, for instance, I need to run mphmesh..... . For that, two calculations are done, which is unnecessary.

Is there a possibility, like in Comsol 3.5 with MATLAB, to store the whole solution of a model in a variable, which the commands (mph...) can be run on, without recalculating for every step?


0 Replies Last Post 2011年4月19日 GMT-4 09:04
COMSOL Moderator

Hello Philipp Fischer

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.