Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problem with Contact Resistance
Posted 2011年5月2日 GMT-4 14:58 Version 4.0a 1 Reply
Please login with a confirmed email address before reporting spam
Hello All,
I have a model in which I am trying to insert contact resistance between the portion labeled "A" and "B". It worked previously however now it is not.
If someone could look at my model and tell me if I changed a setting I would appreciate it.
Thank you for your assistance.
Regards,
John Haase
I have a model in which I am trying to insert contact resistance between the portion labeled "A" and "B". It worked previously however now it is not.
If someone could look at my model and tell me if I changed a setting I would appreciate it.
Thank you for your assistance.
Regards,
John Haase
Attachments:
1 Reply Last Post 2011年5月3日 GMT-4 02:24
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
there are 2 things:
1) when you use pairs, you must select the pair in the list to populate the boundary block, that was not done for your resistive layer
2) you must define your material properties for your boundary. when you define a material it applies strictly to "domains" or exclusively to Boundaries (not to both) so you are better off using "User defined thin boundary layer material data. Or you must define a new material entry (even if the same as one of the two others, which one for a common boundary ? and select boundary material properties)
--
Good luck
Ivar
there are 2 things:
1) when you use pairs, you must select the pair in the list to populate the boundary block, that was not done for your resistive layer
2) you must define your material properties for your boundary. when you define a material it applies strictly to "domains" or exclusively to Boundaries (not to both) so you are better off using "User defined thin boundary layer material data. Or you must define a new material entry (even if the same as one of the two others, which one for a common boundary ? and select boundary material properties)
--
Good luck
Ivar