Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coupling between rf and electric currents
Posted 2018年5月22日 GMT-4 07:30 Low-Frequency Electromagnetics, RF & Microwave Engineering Version 5.3a 0 Replies
Please login with a confirmed email address before reporting spam
I would like to set a fixed potential in the rf module. If I use the lumped port I can set a potential, but this only applies if wave exication is enabled. When I activate this, my model becomes very complicated and the solver takes a very long time. To avoid this, I wanted to define the potential with the electrica currents physic. The problem is that the defined potential in electrican current module does not exist in the rf module. Because the two modules are not coupled. The question is can the two modules be coupled? And if so, could someone show me how? In the appendix is a model example.
I would be very grateful for any idea!!!
Attachments:
Hello Dejan
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.