Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Deformed geometry in COMSOL 4.1

Please login with a confirmed email address before reporting spam

Hi,

I'm trying to simulate the thermal dependencies of a photonic crystal fiber's fundamental mode. What I want to do is use the deformed geometry computed by the thermo-elastic module (stationary solver) to compute the change of effective index of the fundamental. I followed the procedure given by a former discussion (www.comsol.dk/community/forums/general/thread/15185/) but I can have it work correctly.
The problem is that the mesh generating by right clicking on solution and then click on Remesh Deformed Configuration is not deformed.

Any help would be greatly appreciated!


R.L


0 Replies Last Post 2011年5月16日 GMT-4 19:52
COMSOL Moderator

Hello Rachik Laouar

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.