Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling assembly process
Posted 2018年7月24日 GMT-4 16:32 MEMS & Nanotechnology, Structural & Acoustics, General, MEMS & Piezoelectric Devices, Geometry, Mesh, Structural Mechanics Version 5.3a 0 Replies
Please login with a confirmed email address before reporting spam
Hi all,
I'd like to simulate an assembly process (soldering) in microelectronics packaging which follows these steps:
1) A substrate and a metal lid are separately heated to temperature T1 2) The substrate and the lid get connected by a thin layer of solder 3) The whole package is cooled down to T2
I'd like to see how the residual stresses look like in the whole system after the assembly process. I'd be thankful to know your thoughts.
Regards, Ben
Hello Ben Gholami
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.