Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

swept mesh for revolved geometry

NaveenKumar Honnagondanahalli

Please login with a confirmed email address before reporting spam

Hi friends,

I am Naveen. I tried to do the swept mesh for the recolved tube. but could not it gives me an error saying source and target faces must be specified.Plz help me how to go abt it.

Thanks and regards,
Naveen.

0 Replies Last Post 2009年12月9日 GMT-5 17:16
COMSOL Moderator

Hello NaveenKumar Honnagondanahalli

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.