Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"Unable to write solution data" error in parameter sweep

Posted 2019年1月7日 GMT-5 14:14 Electromagnetics, Piezoelectric Devices, Structural & Acoustics Version 5.3a 2 Replies

Ilya Kubasov
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am new to COMSOL. Now I'm trying to calculate a deflection of a piezoelectric bimorph with a complex geometry when dc voltage is applied, . I have created working model which calculated good results, very close to my experiments, but when I tried to make a sweep with one of parameters the error of solver "Unable to write solution data." occured

Any help will be highly appreciated.

Thanks,

Ilya

2 Replies Last Post 2019年1月9日 GMT-5 10:33
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 2019年1月7日 GMT-5 15:20

Ilya,

Try to close Comsol, then open model and solve again.

Regards,

Sergei

Ilya, Try to close Comsol, then open model and solve again. Regards, Sergei
Ilya Kubasov
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 6 years ago 2019年1月9日 GMT-5 10:33

Sergei, it seems to be working, the program calculated the entire sweep range without the error.

Thank you!

Sergei, it seems to be working, the program calculated the entire sweep range without the error. Thank you!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content