Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

building a magnetic field using a coil

Posted 2011年9月22日 GMT-4 07:39 Version 4.0 1 Reply

Ricardo Canudas
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,

I am new in comsol so i need a little bit of help to get started,

i need to generate a magnetic field using a coil where i can change the properties of it ( how many turns , the current that is flowing , etc..)

if anyone could help me would be great
thanks
1 Reply Last Post 2011年9月22日 GMT-4 14:16
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年9月22日 GMT-4 14:16
Hi

for that you use typically a parametric sweep of the"continuation" type (in v4), basically if the surface of the coil remains (no volume changes) then adding coil turns basically multiplies the average coil section curent by "N"

--
Good luck
Ivar
Hi for that you use typically a parametric sweep of the"continuation" type (in v4), basically if the surface of the coil remains (no volume changes) then adding coil turns basically multiplies the average coil section curent by "N" -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content