Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
I can't plot data from a stopped parametric sweep
Posted 2019年1月23日 GMT-5 16:16 General, Parameters, Variables, & Functions, Results & Visualization Version 5.3 0 Replies
Please login with a confirmed email address before reporting spam
I had a parametric sweep running for a long time and wanted to stop it mid-run and see what I have so far. I followed this thread:
https://www.comsol.com/forum/thread/41643/interrupting-parametric-sweep-without-loosing-results
But when I try to plot my data, nothing pops up except for my geometry. The legend outside the plot is there and changes depending on what parameter I pick from the sweep. The data looks like it's there. It takes a long time for COMSOL to "plot" when I click on a different parameter and then it just shows the geometry again.
What can I do from here?
EDIT: This only applies to data sets that are mirrored, apparently. I can plot the raw data. If I put it through a Mirror data set it just comes up blank.
Hello Damian Rivas
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.