Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D modelling of four core cable

Posted 2019年10月1日 GMT-4 06:15 Electromagnetics, Low-Frequency Electromagnetics, Introduction 1 Reply

Craig
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am new to comsol so forgive any ignorance I show.

I am trying to invesigate the electrical characteristics of a four core LV cable by using a 2d model. So far I have been able to build the geomtry and add the material properties but am having difficulty in adding the circuit aspect, injecting currents etc., how should I go about this?

I built my model using magnetic fields physics as I want to investigate induction and induced currents.

Thanks

1 Reply Last Post 2019年10月1日 GMT-4 13:02
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2019年10月1日 GMT-4 13:02
Updated: 5 years ago 2019年10月1日 GMT-4 09:02

Craig,

Attached reference to the tutorial might help:

https://www.comsol.com/model/cable-tutorial-series-43431

Regards,

Sergei

Craig, Attached reference to the tutorial might help: https://www.comsol.com/model/cable-tutorial-series-43431 Regards, Sergei

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content