Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to reuse the result of a previous simulation as an input for the second simulation?
Posted 2020年3月18日 GMT-4 23:34 Structural & Acoustics, General, Geometry, Mesh, Studies & Solvers, Structural Mechanics 6 Replies
Please login with a confirmed email address before reporting spam
Hi, I am looking for the steps needed to reuse a deformed hyperelastic shape with stress results created in response to a prescribed displacement, for a second simulation with new boundary conditions. Thank you in advance,
Please login with a confirmed email address before reporting spam
Hi Montassar,
Exactly what type of change is it that you are going to do to the boundary conditions?
-------------------Henrik Sönnerlind
COMSOL
Please login with a confirmed email address before reporting spam
Hi Mr Henrik
I am just trying to Disable the Prescribed Displacement of Study 1 Enable the Fixed Constraint Boundary Load of Study 2, and apply to the deformed shape with stress results of Study 1.
Attachments:
Please login with a confirmed email address before reporting spam
This is not trivial. Removing a constraint will for example usually give some springback.
Things are also very different if for example plastic deformations are involved (since for an elastic problem, the path to the final state is not interesting).
One way of removing a constraint smoothly is to implement it using a penaly formulation, and gradually remove the penalty factor. See also https://www.comsol.com/blogs/how-to-make-boundary-conditions-conditional-in-your-simulation
-------------------Henrik Sönnerlind
COMSOL
Please login with a confirmed email address before reporting spam
Hi, I would like to simulate the band gap of a deformed phononic crystal. Firstly, I will simulate the deformation of the porous structure under the external load, and then, the deformed structure with initial stresses can be useded as the new geometric input for the next step. I see the details in the following blog post: www.comsol.com/blogs/how-to-reuse-a-deformed-shape-as-a-geometry-input/. However, when I use this technique, several strange lines are at the surface of the input model. Moreover, this input model has no initial stresses. So how can I export the deformed structure with initial stresses for next study? Do you have other methods? Thanks in advance. Best regards, Haishan Tang
Attachments:
Please login with a confirmed email address before reporting spam
Hi Haishan Tang In fact, your question is what I'm looking for. unfortunately, so far I haven't been able to find an answer, maybe Mr. Henrik's suggestions might help, but I think it is not the exact or simplest way to solve the problem.
Please login with a confirmed email address before reporting spam
Regarding the last update of my inquiry, I solved by some simple steps, First, instead of two 'Stationary' simulations, I used one 'Time-dependent' to integrate a sequence of simulations. Second, Instead of the 'Prescribed Displacement', I used 'Boundary Load', and by this, I could eliminate the applied force gradually during the simulation by using an 'Interpolation' function, which is not possible by using 'Prescribed Displacement'. (The same idea of M. Henrik I think.) And third, placing anchors to hold the new deformed shape during the simulation. I hope this will help the future reader,
Attachments: