Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cannot resolve for " center of coil" error .

Posted 2020年3月29日 GMT-4 12:58 Low-Frequency Electromagnetics, Charged Particle Tracing 1 Reply

Shweta Indra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am designing solenoid for charged particle tracing but I couldn't resolve for the error "cannot determine centre of the coil" under magnetic fields node.

1 Reply Last Post 2020年4月1日 GMT-4 08:07
Lars Dammann COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2020年4月1日 GMT-4 08:07

Hi, do you have your Coil set to "Circular"? Did you select a circular edge in the "Coil Geometry" subnode of the Coil node? If that does not work, perhaps try the "Numeric" coil type. See these example models that may be helpful: https://www.comsol.com/model/magnetic-field-of-a-helmholtz-coil-15 and https://www.comsol.com/model/multi-turn-coil-above-an-asymmetric-conductor-plate-13777

Hi, do you have your Coil set to "Circular"? Did you select a circular edge in the "Coil Geometry" subnode of the Coil node? If that does not work, perhaps try the "Numeric" coil type. See these example models that may be helpful: https://www.comsol.com/model/magnetic-field-of-a-helmholtz-coil-15 and https://www.comsol.com/model/multi-turn-coil-above-an-asymmetric-conductor-plate-13777

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content