Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with lower coil excitation frequency in Magnetic Field mf module

Posted 2020年4月24日 GMT-4 00:45 Low-Frequency Electromagnetics, General Version 5.4 2 Replies

Siripong Cheanklin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I'm working on the eddy current sensor simulation with the different target material. According to my model, I cannot apply the coil excitation frequency lower than 20 kHz, for example, 1,000 Hz. The results do not converge.

Please advise how to adjust the simulation model to solve this problem.

Many thanks,

Siripong

Attachments:

2 Replies Last Post 2020年4月25日 GMT-4 04:38
Sergei Yushanov Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年4月24日 GMT-4 09:31

Siripong,

This is so called conductivity scaling effect - set air conductivity to some small number, say 1 S/m, then Compute.

Regards

Sergei

Siripong, This is so called conductivity scaling effect - set air conductivity to some small number, say 1 S/m, then Compute. Regards Sergei

Attachments:

Siripong Cheanklin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年4月25日 GMT-4 04:38

Dear Sergei

Thank you very much!

Siripong

Dear Sergei Thank you very much! Siripong

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content