Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
avoided 2783 inverted elements by using linear geometry shape order
Posted 2012年1月31日 GMT-5 13:43 Computational Fluid Dynamics (CFD), Geometry, Mesh, Studies & Solvers Version 3.5a 1 Reply
Please login with a confirmed email address before reporting spam
Hello all;
when i start running my i get this massage what it should mean and how i can avoid this error?
Best regard
when i start running my i get this massage what it should mean and how i can avoid this error?
Best regard
1 Reply Last Post 2012年1月31日 GMT-5 14:09
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it emasn that your mesh "quality" is poor and that when COMSOL tries to fit 2nd order (by default) shape functions ontpo your mesh certain mesh elements are so badly shaped that it cannot use higher order shape elements, so it reverts, locally, to linear shape functions, tis means you will loose resolution in the regions where it happens.
The only way out is to improve your mesh, make it more symmetric (to fit into a spere not a looong elogated rugby ball) or to make your mesh smaller, or to try to use the mesh refiner (there is one you can turn on in the solver sequence, at least in v4)
You can plot "h" hte everage mesh size, or the mesh quality (have forgotten what the variable is called it's somewhere in the doc)
--
Good luck
Ivar
it emasn that your mesh "quality" is poor and that when COMSOL tries to fit 2nd order (by default) shape functions ontpo your mesh certain mesh elements are so badly shaped that it cannot use higher order shape elements, so it reverts, locally, to linear shape functions, tis means you will loose resolution in the regions where it happens.
The only way out is to improve your mesh, make it more symmetric (to fit into a spere not a looong elogated rugby ball) or to make your mesh smaller, or to try to use the mesh refiner (there is one you can turn on in the solver sequence, at least in v4)
You can plot "h" hte everage mesh size, or the mesh quality (have forgotten what the variable is called it's somewhere in the doc)
--
Good luck
Ivar