Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Tunneling Current through ATD
Posted 2020年5月6日 GMT-4 13:42 Semiconductor Devices, Parameters, Variables, & Functions, Studies & Solvers Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
I was looking to do some simulation for a tunneling diode I have been designing. It is essentially a silicon dioxide insulator between two polysilicon mediums (of a particular geometry as shown in the picture below). I have added the materials from the available material options (both from semiconductor materials package and other packages like MEMS). I am looking to calculate the tunneling current through the device from the triangular side to the island side. However, when I do the 2D simulation the results does not show a IV curve as it does in many of the online tutorials, which I am not sure why. Also, I had made a 3D model, also shown, which is more specific with regards to boundary conditions and more explicitly describing the actual device. This is what I am more interested in, but also worked with 2D since it is a bit easier.
Help in figuring out how to check for a tunneling current using the 3D model would be greatly appreciated, as I am relatively new to the software. Further information regarding the design can be seen in the .mph of the 3D version provided.
Note: in the image provided the oxide fill (or oxide tunneling medium) is exagerated for display purposes. It is the correct size in the .mph file.
Hello Aman Gupta
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.