Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing 3D geometry

Posted 2012年2月5日 GMT-5 15:53 Mesh Version 4.2a 0 Replies

Cindy Duong
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to figure out the correct way to mesh a 3D geometry that consisted of a chamber containing several cells as shown in the attached figure. When I applied the free tetrahedral mesh to the entire geometry I was able to model the diffusion of my analyte of interest but my domain point probe plot do not show the concentration vs. time for the two points I have set as 60 um above the bottom of the chamber (hence on the same level as the cells). This makes me think that meshing is just a surface mesh and not a volume mesh as evident by a very low mesh volume in the statistic menu.

Any help is much appreciated,
CDuong

Attachments:

0 Replies Last Post 2012年2月5日 GMT-5 15:53
COMSOL Moderator

Hello Cindy Duong

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content