Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D-axisymmetric vs 3D in magnetic (AC/DC) simulation

Posted 2020年5月12日 GMT-4 06:52 Low-Frequency Electromagnetics Version 5.5 0 Replies

Panson Poon
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have been simulating a motor assembly of a transducer. The simulation started with 2D-axis model. Everything was looking fine. I then created a 3D model using the 2D exported geometry. Difference between the 3D and the 2D results are rather large. The two models are enclosed for reference.

Force factor vs displacement of the two models

Is the difference solely dependent on the mesh density of 3D model? Anything more/deeper than that?

Please help me to understand.

Thank you!

0 Replies Last Post 2020年5月12日 GMT-4 06:52
COMSOL Moderator

Hello Panson Poon

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content