Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to make a omega shape in comsol using 3D geomety

Posted 2020年6月8日 GMT-4 20:09 Low-Frequency Electromagnetics, Geometry, Modeling Tools & Definitions Version 5.2a 1 Reply

Ayesha Lakra
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am trying to make a microstrip line with a omega shape in the center of the wire. I tried using a rectangular block and then added another block to it but I cannot bend the lines or add a circle(because I am in 3D geometry) to make an omega shape. I am new to COMSOL so any help is appreciated. Thanks.

1 Reply Last Post 2020年6月9日 GMT-4 08:12
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年6月9日 GMT-4 08:12
Updated: 4 years ago 2020年6月9日 GMT-4 08:39

Hello Ayesha,

You will find training videos on how to create geometries in COMSOL in the Learning Center. If you still need help after watching those videos, it would be helpful to Discussion Forum users if you could post a sketch of the shape you are trying to create.

Bet regards,

Jeff

-------------------
Jeff Hiller
Hello Ayesha, You will find training videos on how to create geometries in COMSOL in the [Learning Center](https://www.comsol.com/learning-center). If you still need help after watching those videos, it would be helpful to Discussion Forum users if you could post a sketch of the shape you are trying to create. Bet regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content