Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
PML layer & automatic PEC layer
Posted 2012年2月17日 GMT-5 00:55 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
for a 3D RF structure i want to use
1. PML at top & bottom layer (domain)
2. port at front & back
3. periodic boundary condition left-right
Now PEC has automatically (default) set up at the top & bottom surface of PML . I want to get rid of it.
Would you please help me .
Thank you & best regards
Sanjay Debnath
for a 3D RF structure i want to use
1. PML at top & bottom layer (domain)
2. port at front & back
3. periodic boundary condition left-right
Now PEC has automatically (default) set up at the top & bottom surface of PML . I want to get rid of it.
Would you please help me .
Thank you & best regards
Sanjay Debnath
1 Reply Last Post 2012年2月17日 GMT-5 01:33
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I believe you can just "overwrite them. COMSOl starts to define a coherent set of Default (first node icons with the little D) equations and BC, then its up to you to add new nodes that either Contribute (add in) or Overwrite the previous ones. Read carefully the node tree from TOP to BOTTOM. This is important as enven the order of "physics" some time can make your model solve or not (or just give funny results ;)
So add anew BC node and select the side boundaries, then go back to the default node and most probably you will see these being owervritten.
By the way this applias also to material nodes (often the first is for all domains, then new material just overwrite the first selection)
--
Good luck
Ivar
I believe you can just "overwrite them. COMSOl starts to define a coherent set of Default (first node icons with the little D) equations and BC, then its up to you to add new nodes that either Contribute (add in) or Overwrite the previous ones. Read carefully the node tree from TOP to BOTTOM. This is important as enven the order of "physics" some time can make your model solve or not (or just give funny results ;)
So add anew BC node and select the side boundaries, then go back to the default node and most probably you will see these being owervritten.
By the way this applias also to material nodes (often the first is for all domains, then new material just overwrite the first selection)
--
Good luck
Ivar