Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
actuation
Posted 2012年2月27日 GMT-5 08:31 Version 4.2 1 Reply
Please login with a confirmed email address before reporting spam
Hello sir,
I am working on the design of " comb capacitive accelerometer".
How do I give a sinusoidal actuation, before evaluating the simulation?
Thank you
I am working on the design of " comb capacitive accelerometer".
How do I give a sinusoidal actuation, before evaluating the simulation?
Thank you
1 Reply Last Post 2012年2月27日 GMT-5 10:32
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
check your doc and the FORUM (try a search), normally for time dependent solvers you define a load or driving voltage as V0*sin(2*pi*f*t) where f is the frequency and t the time in seconds, and V0 the amplitude. But you can also solve in frequency sweep / harmonic mode.,Then it's a AC steady state response, in which case you define V0 the amplitude and set the excitation frequency in the Solver frequency entry (possibly you add a phase with a phasor expression see the doc)
--
Good luck
Ivar
check your doc and the FORUM (try a search), normally for time dependent solvers you define a load or driving voltage as V0*sin(2*pi*f*t) where f is the frequency and t the time in seconds, and V0 the amplitude. But you can also solve in frequency sweep / harmonic mode.,Then it's a AC steady state response, in which case you define V0 the amplitude and set the excitation frequency in the Solver frequency entry (possibly you add a phase with a phasor expression see the doc)
--
Good luck
Ivar