Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

decimal places of effective modes calculated

Posted 2012年3月7日 GMT-5 10:49 RF & Microwave Engineering Version 4.2a 3 Replies

Deepak Jain
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

hi,

I have done one fiber simulation. It shows good results. But the problem is with one mode it should show effective mode index with e-9i value. But it does not show it however the modes with imaginary part up to e-7 are being shown here. Is there any thing which restricting comsol to go up to 9 digit place. Is it concerned with mesh. Plesae help.

Thanks
Deepak
3 Replies Last Post 2012年3月7日 GMT-5 17:11
Alexander Kuznetsov
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年3月7日 GMT-5 12:49
In the Results window there is a button "Full Precision". It shows many more decimal places.
In the Results window there is a button "Full Precision". It shows many more decimal places.
Deepak Jain
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年3月7日 GMT-5 13:05
Thanks for reply. I could not find this button. can you please tell me in more detail. I can see three windows Model, setting & graphics. Thanks
Thanks for reply. I could not find this button. can you please tell me in more detail. I can see three windows Model, setting & graphics. Thanks
Alexander Kuznetsov
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年3月7日 GMT-5 17:11
go to View-Desktop Layout-Reset Desktop. Then in the bottom right corner you will see forth window with several tabs. The button in on the Results tab.

You can print your values in the Results tab by defining them in Derived Values-Global Evaluation.
go to View-Desktop Layout-Reset Desktop. Then in the bottom right corner you will see forth window with several tabs. The button in on the Results tab. You can print your values in the Results tab by defining them in Derived Values-Global Evaluation.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content