Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems using mphinterp for extracting Solid.Tn data.

Posted 2020年10月18日 GMT-4 01:23 Structural & Acoustics, Corrosion Processes, LiveLink for MATLAB Version 5.4 2 Replies

Yesenia Villamizar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi.I'm modeling a contact problem between two surfaces in a 2d problem as shown in the attached figure. I cannot get the data because i got this error: "Wrong dimension of points searched for in postinterp." i use mph inter as shown below:

mphinterp(model,'solid.Tn','coord',nuevoxy,'edim','boundary','selection',4)

where nuevoxy is an array with the coordinates x and y of the points in the boundary where i wanna get this data.!

Attachments:

2 Replies Last Post 2021年1月28日 GMT-5 01:34
Lars Gregersen COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年10月20日 GMT-4 09:42
Updated: 4 years ago 2020年10月20日 GMT-4 10:30

Hi Yesinia

Most likely you need to use nuevoxy' instead of nuevoxy. Coordinates in Comsol are columnwise.

Lars

-------------------
Lars Gregersen
Comsol Denmark
Hi Yesinia Most likely you need to use nuevoxy' instead of nuevoxy. Coordinates in Comsol are columnwise. Lars
Yesenia Villamizar
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年1月28日 GMT-5 01:34

Thank u Lars

Thank u Lars

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content