Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

anand model

Please login with a confirmed email address before reporting spam

hello,
i,m solving a model which is quite similar to the "Viscoplastic solder Joints".I have basically heated a square block and i'm trying to find the plastic strain rate using anand's model.I am experiencing convergence issues which is probably because of the sinh function which is used in the anand's model.As long as I heat it to temperatures below 310[K],i'm not experiencing any issues but when i heat my model to high temperatures it doesn't converge..

Looking forward to your suggestions.....
thank u!

1 Reply Last Post 2012年3月23日 GMT-4 14:03

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年3月23日 GMT-4 14:03
Can anyone please help me?
Can anyone please help me?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.