Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling anisotropic Material
Posted 2010年1月26日 GMT-5 23:27 2 Replies
Please login with a confirmed email address before reporting spam
hi,
i need to model a system (a sphere with a dipole in its centre), the model exhibits anisotropic conductivity. i.e. the radial value of electrical conductivity sigma is 10 times less than its tengentational counterpart. i have the local values of these conductivities, my question is whether femlab/comsol accept values of conductivity tensor in local or gloable coordinates. and is there a way to translate local coordinates into global one.
i need to model a system (a sphere with a dipole in its centre), the model exhibits anisotropic conductivity. i.e. the radial value of electrical conductivity sigma is 10 times less than its tengentational counterpart. i have the local values of these conductivities, my question is whether femlab/comsol accept values of conductivity tensor in local or gloable coordinates. and is there a way to translate local coordinates into global one.
2 Replies Last Post 2013年7月26日 GMT-4 06:21
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
take a closer look at your doc, you candefine coordinate systems in COMSOL that then appear in the BC windows as selectable (outside theunderlaying x,y,z and local normal/tangeant coordinates.
Then its a question of plying woth your expression to go from spherical to linear coordinates
Unfortunately there is no easy way to visualise these coordinate systems, I normally use the trik to make temporary load (vector) cases and then visualise the BC "show symbols", this allows me to check the coherence of the directions in my new coordinate system, but then do not forget to delete these unwanted BC's ;)
Good luck
Ivar
take a closer look at your doc, you candefine coordinate systems in COMSOL that then appear in the BC windows as selectable (outside theunderlaying x,y,z and local normal/tangeant coordinates.
Then its a question of plying woth your expression to go from spherical to linear coordinates
Unfortunately there is no easy way to visualise these coordinate systems, I normally use the trik to make temporary load (vector) cases and then visualise the BC "show symbols", this allows me to check the coherence of the directions in my new coordinate system, but then do not forget to delete these unwanted BC's ;)
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hello Ivar,
Would you mind to show an example do display your clever trick? Thank you in advance.
Best regards,
Xuezhou
Would you mind to show an example do display your clever trick? Thank you in advance.
Best regards,
Xuezhou