Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to access Geometry Constraints in COMSOL 5.6

Posted 2021年4月20日 GMT-4 19:29 General, Introduction, Modeling Tools & Definitions Version 5.6 2 Replies

Nicholas Boechler
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am not sure where I can add constraints when building my geometry in the sketch feature? All of the tutorials I have looked at have the constraints option automatically showing up however that is not the case for me. Does anyone know how I can enable these constraints? I have attached an image of what my geometry tab looks like for reference.

Thanks

Attachments:

2 Replies Last Post 2021年4月26日 GMT-4 10:04
Lars Gregersen COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年4月22日 GMT-4 04:22

Hi Nicholas

Maybe you need the Design Module: https://www.comsol.com/design-module

-------------------
Lars Gregersen
Comsol Denmark
Hi Nicholas Maybe you need the Design Module: https://www.comsol.com/design-module
Nicholas Boechler
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年4月26日 GMT-4 10:04

Yes it looks like that is what I need. How do I go about adding that feature?

Yes it looks like that is what I need. How do I go about adding that feature?

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content