Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How does the segregated solver control the convergence of segregated steps?

Please login with a confirmed email address before reporting spam

Hi! I have a multiphysics problem and I need to use segregated solver. When I has the setting as indicated in figure 1, I thought the solver will iterate the step u untill it converges. However, when I check the log, I found that the solver just perform 1 iteration then went to the next step while the relative tolerance is not obtained, as indicated in figure2. The relative tolerance for u is 1e-5. How can I set the segregated solver so that it can compute every step until reaching relative tolerance then go to the next step? Thanks.

Tianyu



0 Replies Last Post 2021年5月1日 GMT-4 09:07
COMSOL Moderator

Hello John Lionel

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.