Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Pipe boundary layer and swept mesh

Posted 2021年7月13日 GMT-4 12:36 Computational Fluid Dynamics (CFD), Mesh 1 Reply

HL ME
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am modeling flow through a pipe (cylindrical domain). Ideally, I would like to create a quad mesh on one circular face of the cylindrical domain and sweep this to the other circular face. Then, I would like to create boundary layer mesh for better wall resolution. However, I cannot create a boundary layer mesh after I have swept out the quad mesh through the domain. Is there a way around this problem?

Thank you!

1 Reply Last Post 2021年7月13日 GMT-4 13:03
HL ME
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年7月13日 GMT-4 13:03

Nevermind, I got it. For anyone wondering, the answer is in this other post: https://www.comsol.com/forum/thread/20719/using-distributed-mesh-in-3d

Maybe I was doing something wrong before, but if you follow those steps it should work (I used quad mesh instead of the triangular mesh used in the post, and it still worked).

Nevermind, I got it. For anyone wondering, the answer is in this other post: https://www.comsol.com/forum/thread/20719/using-distributed-mesh-in-3d Maybe I was doing something wrong before, but if you follow those steps it should work (I used quad mesh instead of the triangular mesh used in the post, and it still worked).

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content