Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inlet: velocity or fully developed flow?

Posted 2021年8月1日 GMT-4 11:23 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 5.6 1 Reply

Clarence Velez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi I am using an "inlet" condition for my model in "laminar flow" physics. What are the differences between "Velocity" and "Fully developed flow"? Which one should I use and is better?

1 Reply Last Post 2021年8月1日 GMT-4 13:47
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年8月1日 GMT-4 13:47

It depends entirely on the physics of your problem.

Fully developed flow is correct if...the flow is fully developed...which happens when there is a sufficiently long straight region ahead of any obstruction.

It depends entirely on the physics of your problem. Fully developed flow is correct if...the flow is fully developed...which happens when there is a sufficiently long straight region ahead of any obstruction.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content