Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Secondary current distribution
Posted 2021年9月18日 GMT-4 01:48 Chemical, Electrochemistry Version 5.6 1 Reply
Please login with a confirmed email address before reporting spam
Hi，guys； I have some questions about Electrode surface setting。 When I use the internal electrode surface interface, I can't find out how to set the electrode potential. However, in the electrode surface option, the electrode potential can be set。
Thank you very much for your help！
Hello Dengfei Yang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Hello Dengfei Yang,
When the electrode conducts well, the electrode domain can be modeled without being drawn and just the electrode surface should be present . But when the electrode conductivity is not good, the electrode domain needs to be drawn during modeling, and the internal electrode surface should also be present. When internal electrode surfaces are present, you can set the electrode potential using boundary conditions such as potential, electrical ground, circuit terminals, etc. Hope it helps you！