Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Error in Interpolation Function
Posted 2021年9月24日 GMT-4 13:10 Fluid & Heat, Heat Transfer 4 Replies
Please login with a confirmed email address before reporting spam
Hello All,
I am currently using an interpolation function, defined using a .txt file, as an time-dependent inlet temperature profile for the 'Heat Transfer in Pipes' interface.
The model successfully calls the function, however, there is a small error in what is called by the input function and what can be measured in the Results section, using a Point Evaluation at the inlet. The error is typically small, fluctuating around plus/minus 0.03 C, except at the beginning and end of the time range where it can reach values of close to plus/minus 0.2 C.
If anyone knows what may be causing this discrepancy, or how to minimize it, that would be greatly appreciated.
Thank you! Andrew
Hello Andrew Holmes
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Hi Andrew Holmes.
Have you soved your problem? If so, could you share your method? I have the exact same problem for my ewbe model.
Please login with a confirmed email address before reporting spam
Hi Andrew Holmes.
Have you soved your problem? If so, could you share your method? I have the exact same problem for my ewbe model.
Please login with a confirmed email address before reporting spam
You mentioned that this difference was seen in the Results. Comsol computed quantities can vary depending on the mesh, discretization, etc. I'm willing to bet that if you modify the mesh, the time-step, the discretization, etc., that you will see that the "discrepancy" in question will also vary somewhat. In other words, this is probably just a byproduct of your using a numerical model with discretized space and time.
-------------------Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
Please login with a confirmed email address before reporting spam
I interpolated into the model which the txt data exported. So I guess this is not the case. Uploaded the file I tested for this problem.
Attachments: