Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
deformation when assembling
Posted 2012年7月3日 GMT-4 12:27 Structural Mechanics Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I met with a problem about deformation when assembling. but i only have the
original separate models before assembling them together. In order to
analyze this process, i have a idea: first, i give a pre-deformation for
the clamp, which may be a little larger than its actual deformation when
assembling; then I import other parts, at the same time, i release the
pre-deformation of the clamp and it will spring back to contact the surface
of other parts. However, i don't know whether i can analyze one model and
then import other model in Comsol.
It's a very tricky problem because if i import both of them at the same
time, they will overlay or interfere.
Does anyone have any suggestion or any method to solve my problem?
Thank you very much
zhengui
I met with a problem about deformation when assembling. but i only have the
original separate models before assembling them together. In order to
analyze this process, i have a idea: first, i give a pre-deformation for
the clamp, which may be a little larger than its actual deformation when
assembling; then I import other parts, at the same time, i release the
pre-deformation of the clamp and it will spring back to contact the surface
of other parts. However, i don't know whether i can analyze one model and
then import other model in Comsol.
It's a very tricky problem because if i import both of them at the same
time, they will overlay or interfere.
Does anyone have any suggestion or any method to solve my problem?
Thank you very much
zhengui
1 Reply Last Post 2012年7月4日 GMT-4 01:34
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
that is probably not very easy, normally your volumes should not interfere, or you need to use perhaps "assembly mode" and add all your linked boundary conditions as pairs, something possible but rapidly long to set up for a more complex model
--
Good luck
Ivar
that is probably not very easy, normally your volumes should not interfere, or you need to use perhaps "assembly mode" and add all your linked boundary conditions as pairs, something possible but rapidly long to set up for a more complex model
--
Good luck
Ivar